The test mangles the GPIO address and the pin number in the
qtest_add_data_func data parameter. Doing so, it assumes that the host
pointer size is always 64-bit, which breaks on 32-bit :
../tests/qtest/stm32l4x5_gpio-test.c: In function ‘test_gpio_output_mode’:
../tests/qtest/stm32l4x5_gpio-test.c:272:25: error: cast from pointer to integer of different size [-Werror=pointer-to-int-cast]
272 | unsigned int pin = ((uint64_t)data) & 0xF;
| ^
../tests/qtest/stm32l4x5_gpio-test.c:273:22: error: cast from pointer to integer of different size [-Werror=pointer-to-int-cast]
273 | uint32_t gpio = ((uint64_t)data) >> 32;
| ^
To fix, improve the mangling of the GPIO address and pin number fields
by using GPIO_SIZE so that the resulting value fits in a 32-bit pointer.
While at it, include some helpers to hide the details.
Cc: Arnaud Minier <arnaud.minier@telecom-paris.fr>
Cc: Inès Varhol <ines.varhol@telecom-paris.fr>
Signed-off-by: Cédric Le Goater <clg@redhat.com>
Message-id: 20240329092747.298259-1-clg@redhat.com
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
The testcase contains :
- `test_idr_reset_value()` :
Checks the reset values of MODER, OTYPER, PUPDR, ODR and IDR.
- `test_gpio_output_mode()` :
Checks that writing a bit in register ODR results in the corresponding
pin rising or lowering, if this pin is configured in output mode.
- `test_gpio_input_mode()` :
Checks that a input pin set high or low externally results
in the pin rising and lowering.
- `test_pull_up_pull_down()` :
Checks that a floating pin in pull-up/down mode is actually high/down.
- `test_push_pull()` :
Checks that a pin set externally is disconnected when configured in
push-pull output mode, and can't be set externally while in this mode.
- `test_open_drain()` :
Checks that a pin set externally high is disconnected when configured
in open-drain output mode, and can't be set high while in this mode.
- `test_bsrr_brr()` :
Checks that writing to BSRR and BRR has the desired result in ODR.
- `test_clock_enable()` :
Checks that GPIO clock is at the right frequency after enabling it.
Acked-by: Thomas Huth <thuth@redhat.com>
Signed-off-by: Arnaud Minier <arnaud.minier@telecom-paris.fr>
Signed-off-by: Inès Varhol <ines.varhol@telecom-paris.fr>
Message-id: 20240305210444.310665-4-ines.varhol@telecom-paris.fr
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
