OrcaSlicer/doc/Chamber-temperature.md

OrcaSlicer use M141/M191 command to control active chamber heater.
If you are using Klipper, you can define these macros to control the active chamber heater.
Bellow is a reference configuration for Klipper.
Note: Don't forget to change the pin name/values to the actual values you are using in the configuration

[heater_generic chamber_heater]
heater_pin:PB10
max_power:1.0
# Note: here the temperature sensor should be the sensor you are using for chamber temperature, not the PTC sensor
sensor_type:NTC 100K MGB18-104F39050L32
sensor_pin:PA1
control = pid
pid_Kp = 63.418 
pid_ki = 0.960
pid_kd = 1244.716
min_temp:0
max_temp:70

[gcode_macro M141]
gcode:
    SET_HEATER_TEMPERATURE HEATER=chamber_heater TARGET={params.S|default(0)}

[gcode_macro M191]
gcode:
    {% set s = params.S|float %}
    {% if s == 0 %}
        # If target temperature is 0, do nothing
        M117 Chamber heating cancelled
    {% else %}
        SET_HEATER_TEMPERATURE HEATER=chamber_heater TARGET={s}
        TEMPERATURE_WAIT SENSOR="heater_generic chamber_heater" MINIMUM={s-1} MAXIMUM={s+1}
        M117 Chamber at target temperature
    {% endif %}