The cool_min_temperature should be larger then both the initial and final temperature too avoid that the printer is heating too much and later on waits for cooling. We could make the limit less strict for single extrusion. PP-71
The interlocking_boundary_avoidance was a bit larger originally to prevent interlocking structures outside the model for edge cases. But this behaviour is improved a lot, so the boundary avoidance can be reduced, which helps for thin and small structures.
PP-283
This enlarges small areas to immediately be equal to support_tower_diameter^2.
Contributes to CURA-10220
Co-authored-by: Rijk van Manen <rijk.vanmanen@ultimaker.com>
Decrease `support_offset` setting as using both support towers and support horizontal expansion would apply the same concept twice.
Remove duplicate settings in other ultimaker profiles.
Contributes to CURA-10220
Co-authored-by: Rijk van Manen <rijk.vanmanen@ultimaker.com>
With PP-71 the cool_min_speed is increased to a high values in case the lift_head is enabled. This causes the bridge_speeds to be lower then the cool_min_speed. Which is no problem, so the limit can be removed.
PP-71 / CURA-10211
(cherry picked from commit 6d0be01913)
By default the cool_min_temperature is 15deg below print temperature. However, for PP and TPU this should be 10deg below print temperature. This is already changed for the other ultimaker printers, but I forget the UM3.
PP-71
(cherry picked from commit 0b1b19f0b1)
Slicing becomes very slow for large interlocking_boundary_avoidance and interlocking_depth values. The minimum interlocking_beam_width is the minimum wall line width. And the interlocking_rotation should be between 0 and 360 degrees.
PP-283
For non-Repetier and non-Ultimaker printers - Move the prime extrusion so it occurs while the print head is still in the parked position so the blob doesn't happen over the print (GitHub #13584 and #11471 for reference).
Add a user option to use M104 or M109 for the resume temperature to avoid an unnecessary delay if the resume temperature is the same as the standby temperature.
committed as part of CURA-9822
