mirror of
https://github.com/Motorhead1991/qemu.git
synced 2025-12-24 00:18:36 -07:00
995b30179b
The boot framebuffer is expected to be configured by the firmware, so it uses fw_cfg as interface. Initialization goes as follows: (1) Check whenever etc/ramfb is present. (2) Allocate framebuffer from RAM. (3) Fill struct RAMFBCfg, write it to etc/ramfb. Done. You can write stuff to the framebuffer now, and it should appear automagically on the screen. Note that this isn't very efficient because it does a full display update on each refresh. No dirty tracking. Dirty tracking would have to be active for the whole ram slot, so that wouldn't be very efficient either. For a boot display which is active for a short time only this isn't a big deal. As permanent guest display something better should be used (if possible). This is the ramfb core code. Some windup is needed for display devices which want have a ramfb boot display. Signed-off-by: Gerd Hoffmann <kraxel@redhat.com> Tested-by: Laszlo Ersek <lersek@redhat.com> Message-id: 20180613122948.18149-2-kraxel@redhat.com Signed-off-by: Gerd Hoffmann <kraxel@redhat.com> |
||
|---|---|---|
| .. | ||
| block | ||
| chardev | ||
| crypto | ||
| disas | ||
| exec | ||
| fpu | ||
| hw | ||
| io | ||
| libdecnumber | ||
| migration | ||
| monitor | ||
| net | ||
| qapi | ||
| qemu | ||
| qom | ||
| scsi | ||
| standard-headers | ||
| sysemu | ||
| ui | ||
| elf.h | ||
| glib-compat.h | ||
| qemu-common.h | ||
| qemu-io.h | ||
| trace-tcg.h | ||