mirror of
https://github.com/Klipper3d/klipper.git
synced 2026-01-05 14:27:45 -07:00
Klipper is a 3d-printer firmware
4691243179
The get_temp() code will stop reporting the last temperature of the heater if there hasn't been any recent temperature updates. However, on a full mcu communication loss this can cause the verify_heater code to report a heating error prior to the mcu code reporting the communication failure. Increase the heater timeout from 5 to 7 seconds to make it more likely the mcu failure is reported first. Signed-off-by: Kevin O'Connor <kevin@koconnor.net> |
||
|---|---|---|
| .github | ||
| config | ||
| docs | ||
| klippy | ||
| lib | ||
| scripts | ||
| src | ||
| test | ||
| .gitignore | ||
| COPYING | ||
| Makefile | ||
| README.md | ||
Welcome to the Klipper project!
The Klipper firmware controls 3d-Printers. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use the Klipper software.
Start by installing Klipper software.
Klipper software is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.