Deploying to gh-pages from @ Klipper3d/klipper@06d65ef5ac 🚀

Config_Reference.html

@@ -2601,6 +2601,20 @@
 
             
           
+            
+              
+  
+  
+  
+    <li class="md-nav__item">
+      <a href="Load_Cell.html" class="md-nav__link">
+        Load Cells
+      </a>
+    </li>
+  
+
+            
+          
         </ul>
       </nav>
     </li>
@@ -8268,6 +8282,16 @@ scale.</p>
 <div class="highlight"><pre><span></span><code>[load_cell]
 sensor_type:
 #   This must be one of the supported sensor types, see below.
+#counts_per_gram:
+#   The floating point number of sensor counts that indicates 1 gram of force.
+#   This value is calculated by the LOAD_CELL_CALIBRATE command.
+#reference_tare_counts:
+#   The integer tare value, in raw sensor counts, taken when LOAD_CELL_CALIBRATE
+#   is run. This is the default tare value when klipper starts up.
+#sensor_orientation:
+#   Change the sensor&#39;s orientation. Can be either &#39;normal&#39; or &#39;inverted&#39;.
+#   The default is &#39;normal&#39;. Use &#39;inverted&#39; if the sensor reports a
+#   decreasing force value when placed under load.
 </code></pre></div>
 
 <h4 id="hx711">HX711<a class="headerlink" href="#hx711" title="Permanent link">&para;</a></h4>