Support for LIS2DW accelerometers.
[lis2dw]
-cs_pin:
-# The SPI enable pin for the sensor. This parameter must be provided.
+#cs_pin:
+# The SPI enable pin for the sensor. This parameter must be provided
+# if using SPI.
#spi_speed: 5000000
# The SPI speed (in hz) to use when communicating with the chip.
# The default is 5000000.
@@ -5425,6 +5440,43 @@ cs_pin:
#spi_software_miso_pin:
# See the "common SPI settings" section for a description of the
# above parameters.
+#i2c_address:
+# Default is 25 (0x19). If SA0 is high, it would be 24 (0x18) instead.
+#i2c_mcu:
+#i2c_bus:
+#i2c_software_scl_pin:
+#i2c_software_sda_pin:
+#i2c_speed: 400000
+# See the "common I2C settings" section for a description of the
+# above parameters. The default "i2c_speed" is 400000.
+#axes_map: x, y, z
+# See the "adxl345" section for information on this parameter.
+
Support for LIS3DH accelerometers.
+[lis3dh]
+#cs_pin:
+# The SPI enable pin for the sensor. This parameter must be provided
+# if using SPI.
+#spi_speed: 5000000
+# The SPI speed (in hz) to use when communicating with the chip.
+# The default is 5000000.
+#spi_bus:
+#spi_software_sclk_pin:
+#spi_software_mosi_pin:
+#spi_software_miso_pin:
+# See the "common SPI settings" section for a description of the
+# above parameters.
+#i2c_address:
+# Default is 25 (0x19). If SA0 is high, it would be 24 (0x18) instead.
+#i2c_mcu:
+#i2c_bus:
+#i2c_software_scl_pin:
+#i2c_software_sda_pin:
+#i2c_speed: 400000
+# See the "common I2C settings" section for a description of the
+# above parameters. The default "i2c_speed" is 400000.
#axes_map: x, y, z
# See the "adxl345" section for information on this parameter.