Deploying to gh-pages from @ Klipper3d/klipper@877b63a28c 🚀

Eddy_Probe.html

@@ -1431,7 +1431,7 @@ complete in a few seconds.  After it completes, issue a <code>SAVE_CONFIG</code>
 command to save the results to the printer.cfg and restart.</p>
 <p>The second step in calibration is to correlate the sensor readings to
 the corresponding Z heights. Home the printer and navigate the
-toolhead so that the nozzle is near the center of the bed. Then run an
+toolhead so that the nozzle is near the center of the bed. Then run a
 <code>PROBE_EDDY_CURRENT_CALIBRATE CHIP=my_eddy_probe</code> command. Once the
 tool starts, follow the steps described at
 <a href="Bed_Level.html#the-paper-test">"the paper test"</a> to determine the