mirror of
https://github.com/Ultimaker/Cura.git
synced 2025-07-24 07:03:56 -06:00
2c13f5dc75
It now constrains the value to be no less than 0 when z_offset_layer_0 is negative or z_offset_taper_layers is 0, otherwise the value must be such that the gap between subsequent layers is not less than 80% of the normal layer height. If the print head was lowered for the first layer, the tapering will always cause the subsequent layers to be at least the normal layer height above the previous layer so the tapering can occur over any number of layers. On the other hand, if the print head was raised for the first layer, we demand that either tapering is not used (value is 0) or that the tapering occurs over sufficient layers so that the inter-layer gaps are not too small. |
||
|---|---|---|
| .. | ||
| definitions | ||
| extruders | ||
| i18n | ||
| images | ||
| meshes | ||
| qml | ||
| quality | ||
| shaders | ||
| themes | ||
| variants | ||