These formulas were using a setting that didn't exist any more.
Not sure how this got through QA. Oh well, this is what they are intending.
This formula is a little bit weird in how it works with support meshes if support is disabled, but it's more or less as good as it gets. The formula is mirrored from how other Ultimaker printers write it down, but slightly simplified with the same outcome.
The DoubleValidator depends on the system locale, requiring users with certain locales to enter floats with a comma instead of a dot (though confusingly floats are always represented with a decimal a dot). Instead of configuring the DoubleValidator with a locale that only accepts decimal dots, this commit uses a RegExpValidator, like other numeric fields in Cura does.
After https://github.com/Ultimaker/Cura/pull/8684 raft_airgap and speed_layer_0 existed twice in some of the quality profiles.
This commit fixes that by removing the old (calculated) values.
The draft and ooze shield use the skirt/brim settings to print. So these settings should be adjustable if the draft or ooze shield is enabled. It's a bit weird UX-wise, but it's correct. The UX problem will be tackled later.
Apparently this was already done for the speed/acceleration/jerk settings so no change necessary there.
Contributes to issue #8808.
Two problems with this description:
- It claims that meshes with lower rank override meshes with higher rank. It's the other way around.
- It mentions 'rank' in one sentence and then 'order' in the next. I've corrected this to use the term 'rank' in both sentences for clarity. This is also the term used for the setting label, to be consistent.
Found in issue #8821.
The ProBundle rejects materials which have these values a positive number.
Users should not be allowed to set it to a positive number.
Fixes CURA-7856.
