The case where it reaches '20' is incorrect, it should never give an error, so it should've been 999999 or something. This case is also overly complex.
Say that P is 'infill_line_distance > 0' and Q is 'spaghetti_enabled'...
Then it would be the logarithmic if (P and not Q)...
Then it would be 0 or 20 if (not (P and not Q)), which is ((not P) or Q)...
Then it would be 20 if (((not P) or Q) and not Q), which is (not P)...
And it would be 0 if (((not P) or Q) and Q), which is Q.
So therefore it can be simplified to: 20 if (not P) else 0 if Q else logarithmic. But 20 became 999999, hence the above formula.
Contributes to issue CURA-3700.
The combination PC-0.4 and PVA-0.8 wouldn't print because the raft was getting so big that it intersected with the prime tower. Moving the prime tower 1mm down allows us to print again.
Contributes to issue CURA-3650.
It's not a problem to have lower jerk. It'll just print corners quite slow. But sometimes that's necessary, for example for PVA.
Contributes to issue CURA-3650.
With very thick layers, fewer layers will still provide enough strength to not sag. 2 is quite a hard minimum though because there are 2 different orientations.
Contributes to issue CURA-3650.
infill_overlap and infill_overlap_mm were in conflict with each other. Went to the Materials team to resolve it. They say it should be 0.
Contributes to issue CURA-3650.
The 3mm was computed from wanting 7 lines, but in that calculation I used a line width of 0.4mm. This is obviously wrong, since for 0.8mm profiles the line width is 0.8mm.
Contributes to issue CURA-3650.
It was being violated by the superdraft profiles. With very thick layers, 2 layers of interface suffices. But 2 layers is not quite enough for very thin layers. So I'm making it scale a bit more slowly with an offset.
Contributes to issue CURA-3650.
Some of them ended up as 15 because that's the default in the Ultimaker 3. This was done correctly by the profile optimiser because this setting was not specified by the original profiles, but it should've been 20 for all AA 0.8mm profiles.
Contributes to issue CURA-3650.
