In the fdmprinter definition the 'infill' is created by 999999 bottom layers to change to infill pattern to lines. This hack is reverted for ultimaker printers. More info: PP-25
In the fdmprinter definition the 'infill' is created by 999999 bottom layers to change to infill pattern to lines. This hack is reverted for ultimaker printers. More info: PP-25
Instead of the minimum. So previously a value of 2 would make it spread the error over 2 walls for an even number, or 3 for an odd. Now it makes it spread the error over 2 walls for an even number or 1 for an odd. This means that the minimum allowed value becomes 2, because for an even wall count it needs to place the error somewhere.
Done as a 5 minute fix.
Conflicts:
resources/definitions/ultimaker2.def.json -> Additions in Arachne around a place where we fixed an enum setting.
resources/definitions/ultimaker3.def.json
resources/definitions/ultimaker_s3.def.json
resources/definitions/ultimaker_s5.def.json
This variable makes more sense to as a Ratio.
This was discussed during the eCCB 12/11/21
and implemented as a 5 min fix.
Note: The current default values were 0.5 there
is a new PR which change these 1.0. These values
should be multiplied with a 100
There is no theoretical or algorithmic limit here. We may warn the user, but not prevent them from changing it.
Done as a five minute fix. Fixes CURA-8693. Fixes#10736.
It doesn't work for those patterns at the moment. For Gyroid it could be made to work. For Cross and Cross 3D it's a bit more difficult due to the pre-calculations and density image done for those.
Contributes to issue PP-55. Done as a 5 minute fix.
These two have garnered some feedback in that it's wholly unclear what the sentences even mean. Hopefully this correction makes it more clear for next time.
Contributes to issue CURA-8638.
Two changes have been made:
- Use more consistent terminology for the top side of the model (which could be skin or walls). This is corrected from feedback by our translators.
- Don't add disclaimers about the infill density to this already way-too-long setting description. If anything, a disclaimer should be added to the infill density description that Gradual Infill and some infill patterns might not reach the desired density everywhere. But really, I think it's more in the domain of user documentation like the Ultimaker website or the Settings Guide.
