diff --git a/config/examples/AnyCubic/i3 Mega/Configuration.h b/config/examples/AnyCubic/i3 Mega/Configuration.h
index b31e1ad2da..6eee880409 100644
--- a/config/examples/AnyCubic/i3 Mega/Configuration.h	
+++ b/config/examples/AnyCubic/i3 Mega/Configuration.h	
@@ -2912,7 +2912,7 @@
 // Use software PWM to drive the fan, as for the heaters. This uses a very low frequency
 // which is not as annoying as with the hardware PWM. On the other hand, if this frequency
 // is too low, you should also increment SOFT_PWM_SCALE.
-//#define FAN_SOFT_PWM
+#define FAN_SOFT_PWM
 
 // Incrementing this by 1 will double the software PWM frequency,
 // affecting heaters, and the fan if FAN_SOFT_PWM is enabled.
diff --git a/config/examples/AnyCubic/i3 Mega/Configuration_adv.h b/config/examples/AnyCubic/i3 Mega/Configuration_adv.h
index e80cb24212..2dd81d78f9 100644
--- a/config/examples/AnyCubic/i3 Mega/Configuration_adv.h	
+++ b/config/examples/AnyCubic/i3 Mega/Configuration_adv.h	
@@ -516,7 +516,7 @@
  */
 #define USE_CONTROLLER_FAN
 #if ENABLED(USE_CONTROLLER_FAN)
-  #define CONTROLLER_FAN_PIN TG_FAN1_PIN    // Set a custom pin for the controller fan
+  #define CONTROLLER_FAN_PIN 7              // Set a custom pin for the controller fan
   //#define CONTROLLER_FAN_USE_Z_ONLY       // With this option only the Z axis is considered
   //#define CONTROLLER_FAN_IGNORE_Z         // Ignore Z stepper. Useful when stepper timeout is disabled.
   #define CONTROLLERFAN_SPEED_MIN         0 // (0-255) Minimum speed. (If set below this value the fan is turned off.)
diff --git a/config/examples/AnyCubic/i3/Configuration_adv.h b/config/examples/AnyCubic/i3/Configuration_adv.h
index d19aeb498e..a3c3555683 100644
--- a/config/examples/AnyCubic/i3/Configuration_adv.h
+++ b/config/examples/AnyCubic/i3/Configuration_adv.h
@@ -613,7 +613,7 @@
  * Multiple extruders can be assigned to the same pin in which case
  * the fan will turn on when any selected extruder is above the threshold.
  */
-#define E0_AUTO_FAN_PIN TG_FAN2_PIN
+#define E0_AUTO_FAN_PIN 44
 #define E1_AUTO_FAN_PIN -1
 #define E2_AUTO_FAN_PIN -1
 #define E3_AUTO_FAN_PIN -1