🚸 DGUS "Reloaded" DWIN_SET

config/examples/Creality/Ender-5 Plus/BigTreeTech SKR 3/README.md

@@ -10,7 +10,28 @@ Four pins, tx2-pa10 rx2-pa9 gnd-g 5v-+5v, ( See the boards silkscreens for pin l
 
 These are configuration files for the Ender 5 Plus to work with a BTT SKR 3 motherboard using the stock LCD with A4988 stepper drivers.
 
-## Marlin DGUS UI Instructions
+## Marlin DGUS UI "Reloaded" Instructions
 
-The stock LCD needs to be flashed with a custom LCD firmware available from https://github.com/Desuuuu/DGUS-reloaded/wiki/Flashing-the-firmware
+To use `DGUS_LCD_UI RELOADED` the stock LCD must be flashed with custom firmware.
 
+### Get the DWIN_SET
+
+- Download the `DWIN_SET` archive from https://github.com/MarlinFirmware/Configurations/raw/bugfix-2.1.x/config/examples/Creality/Ender-5%20Plus/DGUS-Reloaded/DWIN_SET.tar.gz
+- Extract the contents of the archive. You should now have a folder called `DWIN_SET`.
+
+### Prepare the SD Card
+
+- Format a Micro-SD card, selecting FAT32 for the file system and 4096 bytes sector size. These parameters are required for the procedure to work.
+- Copy the `DWIN_SET` folder to the root of the Micro-SD card.
+- Unmount and unplug your Micro-SD card.
+
+### Flash the touchscreen
+
+- Turn off and unplug your printer (both power and USB).
+- You will need to access the Micro-SD slot on the back of the touchscreen (not the one that may be on your mainboard). If necessary, open the printer to access this slot.
+- Insert the Micro-SD card into the screen SD slot.
+- Plug the printer's power cable back in (but not the USB cable) and turn on the printer.
+- After a few seconds the screen background will turn blue and the firmware flash will begin. _Do not cut power to the printer while the procedure is running!_
+- When the procedure ends the screen will display a blue background with an END message and summary.
+- Turn off the printer. Remove the Micro-SD card from the touchscreen. Reassemble the printer if needed.
+- The touch-screen firmware is now up-to-date.