XY Freq, Singlenozzle Standby

config/examples/Geeetech/M201/Configuration_adv.h

@@ -786,10 +786,16 @@
   #define SLOWDOWN_DIVISOR 2
 #endif
 
-// Frequency limit
-// See nophead's blog for more info
-// Not working O
-//#define XY_FREQUENCY_LIMIT  15
+/**
+ * XY Frequency limit
+ * Reduce resonance by limiting the frequency of small zigzag infill moves.
+ * See http://hydraraptor.blogspot.com/2010/12/frequency-limit.html
+ * Use M201 F<freq> G<min%> to change limits at runtime.
+ */
+//#define XY_FREQUENCY_LIMIT      10 // (Hz) Maximum frequency of small zigzag infill moves. Set with M201 F<hertz>.
+#ifdef XY_FREQUENCY_LIMIT
+  #define XY_FREQUENCY_MIN_PERCENT 5 // (percent) Minimum FR percentage to apply. Set with M201 G<min%>.
+#endif
 
 // Minimum planner junction speed. Sets the default minimum speed the planner plans for at the end
 // of the buffer and all stops. This should not be much greater than zero and should only be changed
@@ -1381,6 +1387,7 @@
   //#define AO_EXP2_PINMAP      // AlephObjects CLCD UI EXP2 mapping
   //#define CR10_TFT_PINMAP     // Rudolph Riedel's CR10 pin mapping
   //#define S6_TFT_PINMAP       // FYSETC S6 pin mapping
+  //#define CHEETAH_TFT_PINMAP  // FYSETC Cheetah pin mapping
   //#define E3_EXP1_PINMAP      // E3 type boards (SKR E3/DIP, FYSETC Cheetah and Stock boards) EXP1 pin mapping
   //#define GENERIC_EXP2_PINMAP // GENERIC EXP2 pin mapping
 
@@ -1884,7 +1891,7 @@
     // (May break filament if not retracted beforehand.)
     //#define TOOLCHANGE_FS_INIT_BEFORE_SWAP
 
-    // Prime on the first T command even if the same or no toolchange / swap
+    // Prime on the first T0 (If other, TOOLCHANGE_FS_INIT_BEFORE_SWAP applied)
     // Enable it (M217 V[0/1]) before printing, to avoid unwanted priming on host connect
     //#define TOOLCHANGE_FS_PRIME_FIRST_USED