mirror of
https://github.com/MarlinFirmware/Configurations.git
synced 2025-07-11 16:57:56 -06:00
parent
296367b567
commit
03dc42df2a
358 changed files with 3570 additions and 3212 deletions
|
@ -1754,19 +1754,20 @@
|
|||
*/
|
||||
//#define POWER_LOSS_RECOVERY
|
||||
#if ENABLED(POWER_LOSS_RECOVERY)
|
||||
#define PLR_ENABLED_DEFAULT false // Power Loss Recovery enabled by default. (Set with 'M413 Sn' & M500)
|
||||
//#define BACKUP_POWER_SUPPLY // Backup power / UPS to move the steppers on power loss
|
||||
//#define POWER_LOSS_ZRAISE 2 // (mm) Z axis raise on resume (on power loss with UPS)
|
||||
//#define POWER_LOSS_PIN 44 // Pin to detect power loss. Set to -1 to disable default pin on boards without module.
|
||||
//#define POWER_LOSS_STATE HIGH // State of pin indicating power loss
|
||||
//#define POWER_LOSS_PULLUP // Set pullup / pulldown as appropriate for your sensor
|
||||
#define PLR_ENABLED_DEFAULT false // Power Loss Recovery enabled by default. (Set with 'M413 Sn' & M500)
|
||||
//#define PLR_BED_THRESHOLD BED_MAXTEMP // (°C) Skip user confirmation at or above this bed temperature (0 to disable)
|
||||
//#define BACKUP_POWER_SUPPLY // Backup power / UPS to move the steppers on power loss
|
||||
//#define POWER_LOSS_ZRAISE 2 // (mm) Z axis raise on resume (on power loss with UPS)
|
||||
//#define POWER_LOSS_PIN 44 // Pin to detect power loss. Set to -1 to disable default pin on boards without module.
|
||||
//#define POWER_LOSS_STATE HIGH // State of pin indicating power loss
|
||||
//#define POWER_LOSS_PULLUP // Set pullup / pulldown as appropriate for your sensor
|
||||
//#define POWER_LOSS_PULLDOWN
|
||||
//#define POWER_LOSS_PURGE_LEN 20 // (mm) Length of filament to purge on resume
|
||||
//#define POWER_LOSS_RETRACT_LEN 10 // (mm) Length of filament to retract on fail. Requires backup power.
|
||||
//#define POWER_LOSS_PURGE_LEN 20 // (mm) Length of filament to purge on resume
|
||||
//#define POWER_LOSS_RETRACT_LEN 10 // (mm) Length of filament to retract on fail. Requires backup power.
|
||||
|
||||
// Without a POWER_LOSS_PIN the following option helps reduce wear on the SD card,
|
||||
// especially with "vase mode" printing. Set too high and vases cannot be continued.
|
||||
#define POWER_LOSS_MIN_Z_CHANGE 0.05 // (mm) Minimum Z change before saving power-loss data
|
||||
#define POWER_LOSS_MIN_Z_CHANGE 0.05 // (mm) Minimum Z change before saving power-loss data
|
||||
|
||||
// Enable if Z homing is needed for proper recovery. 99.9% of the time this should be disabled!
|
||||
//#define POWER_LOSS_RECOVER_ZHOME
|
||||
|
|
Loading…
Add table
Add a link
Reference in a new issue